The screen protector ships in bulk with no retail package. Please check instruction below for installation steps.Product
Description:
This screen protector is custom-cut for GPS devices with 3.5" screen size. The screen protector is shipped with two backing film to prevent unwanted dust and lints on the actual screen protector. The super-tough transparent film is scratch resistant and will keep your screen look like new for years.
Installation Instruction:
Step 1: Before applying the screen protector, please make sure to clean the screen throughly. The air bubble is usually caused by dust or lint on the screen.
Step 2: The screen protector comes with two backing films. You detach the 1st backing film (transparent) a couple of cm by pulling on orange tab (1).
Step 3: Then you take this side of the screen protector along the suitable position of your device, so you still can get the backing film. Applying the screen protector slowly while removing the 1st backing film. Watch out for air bubbles.
Step 4: After the screen protector covers the screen, you can remove the 2nd backing film (blue) by pulling on the blue tab (2).
Note:
The screen protector is transparent. The blue tint is the backing film.
The small air bubble will usually disappear after few hours.
The screen protector does not have adhesive and can be reapply if needed.
Compatibility:
Garmin
Garmin nuvi 200
Garmin nuvi 205
Garmin nuvi 250
Garmin nuvi 255
Garmin nuvi 260
Garmin nuvi 270
Garmin nuvi 300
Garmin nuvi 310
Garmin nuvi 350
Garmin nuvi 360
Garmin nuvi 500
Garmin nuvi 550
TomTom
TomTom One
TomTom One 2nd Ed.
TomTom One 3rd Ed.
TomTom One 130
TomTom One 130*S
